How to connect your Datalogic Matrix 120 to your computer or PLC, make the connection simple with below service offer by ALC.
20/Sep/2018

The paragraphs in this step show a typical hardware setup depending on the Matrix 120

model and interface selection. To connect the system in a Ethernet point-to-point configuration, you need the hardware indicated in Figure 3. In this layout the data is transmitted to the Host from the Matrix 120 onboard. Ethernet interface by using a CAB-ETH-M01 cable. There is no need to use a crossover adapter since Matrix 120 incorporates an autocross function. Matrix 120 power and I/O device connections take place through the CBX connection box using the CAB-1011 accessory cable. When One Shot or Phase Mode Operating mode is used, the reader is activated by an External Trigger (photoelectric sensor) when the object enters its reading zone.


by: pang






Video